MULTIPLEX Kit+ Tucan Betriebsanleitung PDF herunterladen (Seite 19)

Seite 19

25. Final assembly of the model

Thread the Velcro tape 50 once through the bottom of the

M-frame in the fuselage, forward of the wing retaining screw,

and position it in such a way that it projects by the same

length on both sides. Fix the Velcro in place with a drop

of Zacki Elapor. Attach the wing to the fuselage using the

plastic retaining screw 43. Decorate the model by applying

the decals supplied in the kit. Alternatively you can paint it

in the scheme of your choice using ELAPOR color paints.

26. Installing the ﬂ ight battery, setting the correct Centre

of Gravity

The battery should not be installed until the model can be

completely assembled. Adjust the position of the battery

on the battery tray until the model balances 90 mm from

the root leading edge of the wing, i.e. measured at the fu-

selage, without requiring lead ballast. You will ﬁ nd it easier

to balance the model if you hold it inverted. Use a piece of

Velcro to prevent the battery slipping out of position.

27. Setting the control surface travels

Set the control surface travels as follows:

Ailerons: 15 / 12 mm ± 20% Expo

Elevator: 10 / 8 mm ± 20% Expo

Rudder: 15 / 15 mm ± 10% Expo

Nosewheel: 8 / 8 mm ±

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Keine Kommentare

MULTIPLEX Kit+ Tucan Betriebsanleitung Seite 19